Recoil Hand Installation Tool

The Recoil hand installation tool is the most practical and simple to use for general applications.

This tool may be used to install 1D through to 3D length inserts, but care must be taken to ensure that the adjustable collar is correctly set to suit the particular type and length of the Recoil insert.

If the collar is incorrectly set, the insert will not drive properly and the tool may slip off the tang as the insert enters the hole.

For general use, the collar should be adjusted such that the insert tang is positioned mid-way along the slot with the insert coils compressed.

This will allow the insert free movement to suit the parent material thread pitch during installation.

If the installation tool is used to break off the tang, then it must be lifted clear of the insert following installation and replaced into the insert at 90 degrees to its drive position.

This ensures that the tool is correctly placed on the insert tang.

Tap the tool sharply downward to produce a clean tang break.

Close

Get in Touch

Our team of experts will be glad to answer your questions.

Tech Specs

Please select a product from the options above.

Supplier Part Numbers

  • RECOIL®
  • STANDARD PART NO.
  • HELICOIL® USA
  • (KATO) COILTHREAD®
  • ARMSTRONG
  • BOLLHOFF
  • GERMAN AEROSPACE
  • GE
  • PERMATHREAD

Standards

  • DIN
  • BS

Tech Specs

  • Thread Type
  • Insert Type
  • Insert Style
  • Thread Size
  • Insert Length
  • Nominal Length
  • Bag Qty
  • Manual Installation Tool
  • Installation Mandrel
  • Prewinder
  • Pneumatic Air Prewinder (FEA)
  • Manual Tang Break Tool - (M) Magnetic
  • Spring Tang Break Tool
  • Pneumatic Tang Break Tool
  • Extraction Tool
  • STI Gauge (Screw Thread Insert)
  • Taper Tap
  • Intermediate Tap
  • Bottoming Tap
  • Pilot Nose Tap
  • Spiral Point Tap
  • Spiral Flute Tap
  • Pneumatic Driver
  • Electric Driver
  • Battery Driver
  • Suggested Drill Size (mm)
  • Suggested Drill Size (in)
  • A Minor Min (Tapped Hole Dimension)
  • A Minor Max (Tapped Hole Dimension)
  • B Major Diameter (Tapped Hole Dimension)

Recoil Hand Installation Tool Overview

The Recoil hand installation tool is the most practical and simple to use for general applications.

This tool may be used to install 1D through to 3D length inserts, but care must be taken to ensure that the adjustable collar is correctly set to suit the particular type and length of the Recoil insert.

If the collar is incorrectly set, the insert will not drive properly and the tool may slip off the tang as the insert enters the hole.

For general use, the collar should be adjusted such that the insert tang is positioned mid-way along the slot with the insert coils compressed.

This will allow the insert free movement to suit the parent material thread pitch during installation.

If the installation tool is used to break off the tang, then it must be lifted clear of the insert following installation and replaced into the insert at 90 degrees to its drive position.

This ensures that the tool is correctly placed on the insert tang.

Tap the tool sharply downward to produce a clean tang break.

Key Benefits

Contact us for unparalleled expert advice on our solutions

×