Recoil offer a huge range of insert sizes from 2mm diameter up to 100mm and in virtually all thread forms including METRIC, UNC, UNF, BSC, BA, BSP and BSW. We also stock rarer thread forms such as National Pipe Taper (NPT). Our new Tangless® range of inserts is especially effective for engine and electronics applications.
Recoil inserts are made from a range of materials and with various coatings to suit virtually any type of equipment manufacturing. We also have the expertise to develop new designs to your specification.
-
Hand Prewinder (Lightweight)- For installing tanged inserts by hand
- For medium to high volume applications
- Free running and locking inserts
-
Hand Prewinder (Metallic)- For installing tanged inserts by hand
- For low / medium volume applications
- Free running and locking inserts
-
Front End Assembly (Tanged Inserts)- For installing tanged inserts with a pneumatic driver
- For medium to high volume applications
- Free running and locking inserts
-
Tap- High quality STI taps
- Available in all insert sizes
- Metric, UNC, UNF, BA, BSC, BSF, BSW, NPT
-
Tang break tool- For breaking the tang on tanged inserts
- Used for insert sizes up to 1/2" or M12
- Pneumatic, spring-loaded and hand versions
-
Gauge- Check the hole pre-insert installation
- Best practice to ensure good hole preparation
- Available in medium and close fit
-
Tangless Hand Prewinder- For installing tangless inserts by hand
- For low volume applications
- Free running and locking inserts
-
Insert Removal Tooling- For removing installed inserts
- Solutions for tanged and tangless inserts
- Quick and easy to use
-
Tangless Front End Assembly- For installing tangless inserts with a pneumatic driver
- For medium to high volume applications
- Free running and locking inserts
-
Tangless Front End Assembly (HEX)- For installing tangless inserts with an electric / battery driver
- For medium to high volume applications
- Free running and locking inserts
